Space Handels GmbH
Strietfeld 1
D 17209 Walow
Tel. +49 39932 12640
Fax +49 39932 12641

1/8" / 3 mm
3/16" / 4.5mm
~5/16" / 7.5mm
~1/2" / 13.5mm
3mm.gif (2595 Byte) 45mm.gif (2337 Byte) 75mm.gif (2551 Byte) 135mm.gif (2585 Byte)

It is important to keep up with changes in procedure as quickly as possible, as one of the ways in which customers judge a company is by its working methods. This fact was taken into consideration when developing Space.

Space consists of a plan-parallel disk with a wedge-shaped inclined piece, seven recesses and a groove with funnel-shaped insertion. There are holding lips, which prevent horizontal and vertical slipping within this groove. Clip-in tooth and guiding ridges are present on the topside and underside of the plan-parallel disk. Space is made from polyethylene or polypropylene and is therefore fully recyclable. The thermal load capacity ranges from -15°C to 75°C. In each of the combinations specified in the diagram below, Space has a load-bearing capacity of 1.3t at full force without distortion.

The advantages of Space include:

  • No contraction, even under load pressure!
  • Insertion groove, click-in tooth and guiding ridges prevent slipping in any direction
  • Holding lips prevent slipping out during vertical use
  • Breaking off or splintering is almost completely avoided by the use of polyethylene or polypropylene
  • Only one Space-wedge is required in more than 50% of possible uses, thus avoiding the need for a counter wedge
  • There are only four different coloured basic parts which can be arbitrarily combined in two graduations (fine or rough) and thereby ensure good handling

The economic advantages are:

  • It is no longer necessary to cut small wooden pieces and wedges to size. In addition, the use of Space in height compensation work increases productivity by 30%
  • Highest standard, thereby avoiding the necessity to redo work
  • Fewer risks due to the non-requirement of adapting pieces to fit

Back to the start of page | homepage